Nordyne AireCare 707831C User Manual download pdf (Page 3)

E2 AireCare TM Electronic Air Filter

Installation Instructions

(5 Ton A/C)

Before starting this installation, make sure that

all electrical power to the furnace has been

disconnected.

The 5 Ton E2 AireCare TM ElectronicAir Filter kit

consists of a through the wall grille and frame kit

and the electronic air filter with power cable.

Install Frame

1. Cut a rough-in opening (20" wide by 30"

high) in the door or wall enclosing the E2

furnace.

2. Mount the frame kit into the opening using

screw or wall board anchors.

Connect the AireCare TM

Electronic Air Filter

1. Connectthe electronicairfilterpowerwires

(24 VAC) to the red and gray (or black) low

voltage terminals (R and C). Run this wire

from the E2 furnace to the electronic air

filter and frame. Connect the power wire

marked with a white stripe or dash to C, the

other to R.

2. Place the electronic air filter into the frame

and connect the filter power cable by plug-

ging it into the connector located at the top

of the electronic air filter.

3. Turn on power to the furnace. The

AireCare TM Electronic Air Filter is active if

the light on top of the electronic air filter is

lit.

4. Coverelectronicairfilterwith supplied grille.

E2 Grille

Electronic

Air Filter

Filter

Frame

E2 Frame

Figure 1. E2 Bracket installation

1 2 3 4

Comments to this Manuals

No comments